- - - - - - - - - - - - - - - - - - - - - - - - - - -
West Wight Potter Mailing List maintainer
dfarrell@ridgecrest.ca.us
List hosted by www.tscnet.com
- - - - - - - - - - - - - - - - - - - - - - - - - - -
> on 2/15/00 2:15 PM, jckniese@francomm.com at jckniese@francomm.com wrote:
> Hi Scott,
> To remove bearing buddies just take a hammer and tap up,down, and all
> around. You will see them start to loosen up and then they can be
> pulled off. A puller won't work. When repacking don't pack in too much
> grease or they will pop off when the grease gets warm on the highway.
> Bob
> P19#1148
> Dovie
Also, before I installed lockscrews, I had pretty good luck with just
driving down an Interstate; that managed to remove three, once necessitating
the replacement of the entire axle.
Regards,
Bill Combs
-- WWP 19 #439 (Aug 1987) "Ursa Minor" Fort Walton Beach FL ttursine@earthlink.net http://home.earthlink.net/~ttursine -- Never test the depth of the water with both feet
This archive was generated by hypermail 2b29 : Tue Feb 29 2000 - 03:27:08 PST