Hogging, was Trailer Modifications

Sam Finlay (Sam.Finlay@ey.com)
Tue, 25 Aug 1998 12:34:33 -0400


- - - - - - - - - - - - - - - - - - - - - - - - - - -
West Wight Potter Website at URL
http://www.lesbois.com/wwpotter/
- - - - - - - - - - - - - - - - - - - - - - - - - - -
Bill,
I haven't seen your trailer set up but from what I've read on the subject
hogging is unlikely. Hogging or the sagging of a vessel's ends only occurs in wooden
boats and only traditionally constructed ones at that. Your boat might develop cracks
or even break in two ( not a good thing! ) but it can't hog.
Your concern about support is a good one but maybe you can get by w/ longer bunks?
I've always wondered about the roller versions as they seem to me to concentrate the
loads on the hull in several points ( where each roller contacts the hull ) rather than spread
over a wide area as with conventional bunks. Rollers are quite tempting though as they should
make loading a lot easier. I'm sure someone in the Potter group has
more detailed information about this and I'd like to know more...
Sam
Indomitable, P-15
Luray VA

I apparently have the original trailer that you get when you
order it with the Potter 19. It seems a little short, and I'm
somewhat worried about it hogging on me. Unfortunately, I may
not be able to afford a replacement trailer yet. (I've not yet
checked the prices, I'm afraid to! ;-)

However, I am thinking about modifying my existing trailer. It
is the one with the long carpet covered rails and the two short
rails on either side of the keel at the end of the trailer. One
keel roller up forward and that's it. What I'm thinking of doing
is replacing all these flat rails with rollers instead. West
Marine, for example, has some roller rails the same length as
the current carpet covered ones. I'd like to replace the two
small (<=1') at the end of the trailer with a double roller set-up
as well (two rollers on each side of the keel, in line to replace
the small rails there).

Comments? Recommendations? (I'm not asking for opinions, I know
I'll get those! ;-)

Bill B.
P-19 #454 Dream Catcher
Nampa, ID